How we design
Sized by the numbers.
Jamison designs our duct systems himself. Every project starts with three steps.
Load calculation
How much heating and cooling each room needs, worked out from the house itself.
Equipment selection
Equipment matched to that load, so it isn't oversized and short cycling, or undersized and never catching up.
Duct design
Every run sized for the air it has to carry, so rooms at the far end get their share.
Existing homes
When ductwork is the problem.
Hot and cold rooms
Some rooms never match the thermostat. The ducts aren't delivering the right amount of air.
Weak airflow
Undersized returns or crushed flex duct choke the whole system.
Dust and high bills
Leaky ducts pull attic air in and push conditioned air out.



Project questions
One room is always hot. Can you fix just that?
Usually, yes. It is most often a duct problem: a run that's too long, too small, crushed or leaking. We find out which before recommending anything.
Do you work with builders?
Yes. We design and install systems for new homes and additions, for builders and for homeowners building their own.
What is a load calculation?
It is the math that works out how much heating and cooling a house needs, based on its size, insulation, windows and layout. It is how equipment and ducts get sized properly instead of by rule of thumb.

